Welcome to the BBY Racing Forum

by **RandyatBBY** » Wed Jun 25, 2014 4:38 pm

Just starting a new build with the new bottom permanent mold. The Fiberglass boat came out great. This one is going to be built for Badger at RCCrawlers.com and will be running the Aquacraft 36-56-2030kv motor on 4S1P.

by **RandyatBBY** » Wed Jun 25, 2014 5:16 pm

Plenty of room to lower the profile and a nice big hatch opening.

by **RandyatBBY** » Tue Jul 01, 2014 6:11 pm

Race Basic - hull and basic hardware.

by **RandyatBBY** » Thu Jul 03, 2014 6:32 pm

The correct start to the setup on a strut for the Scat Cat 33 is to hold the rear of the sponsons down on a building board. Then with a 1/8 of a inch plywood sheet under the strut push it flat. Then tighten the bolts carefully not to move the strut.

by **RandyatBBY** » Tue Jul 08, 2014 5:03 pm

This hull is so light and I wanted to keep it that way I decided to use light Ply to strengthen the center of the tunnel.

Hardware mounting on back of boat.

I use a short piece of flax shaft to use a pointer to show whare to start in drilling the hull to make the oval hole for the stuffing tube to go threw.

by **RandyatBBY** » Fri Jul 11, 2014 4:54 pm

I did a little more to the chassis that I will show after the paint is done. But the boat is getting cooler, it is built real light and will be able to go fast with the power to weight ratio it has.
It is in primer now.

by **RandyatBBY** » Mon Jul 21, 2014 5:59 pm

More done on the boat in fact I am finished and the boat is ready for John to come and pickup.

[URL=https://imageshack.com/i/ex1ef565j]

by **RandyatBBY** » Mon Jul 21, 2014 6:00 pm

[/URL]

by **RandyatBBY** » Mon Jul 21, 2014 6:04 pm

by **RandyatBBY** » Mon Jul 21, 2014 6:10 pm

I just like this view.

Welcome to the BBY Racing Forum

BBY Scat Cat 33

BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Re: BBY Scat Cat 33

Who is online